Display frame for embroidery hoop
in 2 sizes and 4 colors
hoop is not included
❤️ Size: available for 5-inch or 6-inch hoops. Check that your 5-inch hoop outer ring is not bigger than 13.6cm, and display zone is not smaller than 12.4.
For the 6-inch hoop is not bigger than 16.2, and display zone is not smaller than 14.9.
Hoops from brands like DMC, and Elbesee fit perfectly.
Be careful, Nurge (Prym) hoops are bigger and their sizes are mentioned in the centimeters. You can order custom sizes for these hoops, write me a message.
❤️ How to use it: gently push on the left and lower petals of the inside hoop, then push the hoop down so the right petals will hold the hoop too. Twist to the side if needed. You can center it by gently pushing it to the required side. There's a video of the inserting process.
❤️ How to hang on the wall: It has an insert and you can hang it on any small hook or nail. I use transparent clips by Command
❤️ Material: PLA (plastic made out of corn starch)
❤️ How it was made: 3D printed
❤️ How to take care of it: don’t leave it outside or under direct sunlight
❤️ How to clean it: wipe with a damp cloth
❤️ What else you need to know: The size of the hoops indicates the display zone (the outer side of the inner hoop) - the zone that is available to display fabric and embroidery. The outer sizes may differ, sometimes for 0,5cm. The petals are remembering the last position they were in. If you place a bigger hoop inside, petals may be pushed harder to the sides. If you want to insert a smaller hoop inside afterward, you need to fix it. Take the hoop out, place a big finger on the inner hoop, and push on the petal with your index finger. Don’t push lower than the big finger or the inner circle of the frame. The petal will go back closer to the original position and you will be able to use it for a smaller hoop.
❤️ For custom sizes write me to direct messages